Would love some help on a model. I'm working on a molle panel for the back of my car. There is a slot that was previously used for a cargo net that I'm trying to use as a support spot for the molle panel. I am using PETG and feel like my print settings are what's causing my failures. I don't know what to change. I've printed with grain across, perpendicular, and at a 30 degree angle. Grain across shears as expected. Perpendicular the tab plugs fail if they even print. At a 30 some parts didn't print right and it sheared. Any advised for printing with PETG would be appreciated. Link for the 3mf is here. https://makerworld.com/en/models/2530030-molle-panel-support-plug-fail#profileId-2784239 I'm 3 months into my 3d printing adventure so pardon my ignorance if it's too obvious. #Questions #Sharing Makes