Clean and simple print

Turned out great!

Great model. Took a bit of a push to get the trays in, and the top is quite tough to remove. Solved the issue by just cutting down the lip near the end of lid to keep it firm, but easy to remove. Everyone's print might be a little different, and I would prefer tighter than too loose.

Real clean print. One of my best showpieces. Only two issues I had, don't know if this will be the case for everyone, and both with easy solutions. -The nubs around the center did not cleanly fit a piece of filament. I just used glue. -The numbers strip has a very minor lip where it connects, leading to an above number of spins landing on a green. Solved this by pre-glueing the ends together.

Printed in a wood infused pla

Great results

Print profile is just fine. I wish the top would "lock in" somehow instead of just loosely screwing in, but isn't really an issue with the slicer settings.

Looks great. Totally stole the idea from the other commenter to replace the gray with red, great call.

Works well! Has survived in my pocket for a month or so now

Looks great

Works a treat. Looks better than expected for a 0.25 layer height,

I switched to a 0.2 nozzle, didn't change anything else. Printed great!