This turned out better than expected. Printed this as a gift for a friend. Was really impressed

Works as intended. The design was very intricate

Used HT-PLA and tested on PETG, PLA, TPU and no warping whatsoever, still works great!

The print profile was great, but I didn't use it as I found another sensor cover that doesn't require taking the whole thing apart

Works great with HT-PLA but I realize the lid does not snap in properly, even with a lot of pressure there's still a chance the dessicant can all spill out if I tip it or have it upside down. otherwise it stays in place just fine. Thanks for the design!

I printed this with HT PLA and had to use a filer to file the legs down a bit so it would. Very tight fit, would probably work better with PETGs flexibility

Works great with HT-PLA

Printed a bunch with PLA, I realize I should of printed with HT-PLA if I want it stick the roll of filament through the dryer

Worked just as described. Printed with some HT-PLA just to be safe

Added some double sided tape to the end so it stayed secured. Worked amazingly

Printed this as a gift for my wife, since I broke my leg and homebound. I wanted something to show my appreciation. She loved it. This was great! Thank you.

Looks good. now to find a string to tie it....

Turned out great but depending on the font, I had to squish the letters closer together, otherwis it falls off. Nothing a little glue can't fix though

Turned out well. Used some glue on the smooth PEI plate so it's easier to remove, not sure if that was a good idea.

This really should be a plate 2 part of the side mount. it's necessary to stop the droop from the mount

This works and fits the AMS1 snuggly. I like this look, over the other popular designs. Might need a little more give to pop the back cover, but it fits snugly with a nice click

Works great. The extra hole at the top to let air pass out works efficiently

Printed this with PLA and love the no hardware solution. However, the filament rubs against the joining part and I can hear it scraping ever so slightly, not sure if this will degrade the splitter over time. Also, the threads started to come apart over time with PLA, so I would suggest something stronger

This works with Creality Space Pi as well. I would highly suggest putting the right side clips as part of this print as well. This left side mount clip, without the otherside, will cause the holder to sag over time.