Sock Clip

This model is made for clipping your socks together. The Sock Clip avoids losing single socks and makes the drying and sorting process after washing much easier. The Sock Clip uses a advanced bending mechanism to lock the socks in place.

It is recommended to use PETG due to its higher melting point and sturdier behavior.

I do not assume any liability for damages.

Disclaimer / Terms of Use

• Use at Your Own Risk: This design is provided "as is" for hobbyist purposes only. I am not a professional engineer and shall not be held liable for any damages (property damage or personal injury) resulting from the use or failure of this model.
• Material Selection & Preparation: You are responsible for choosing the correct filament (e.g., heat-resistant or flame-retardant) for your specific application. Ensure that the filament is completely dry before printing. For maximum structural integrity and mechanical strength, it is necessary to use a freshly unpacked, new spool of filament.
• Electronics Warning: When used in combination with electronics, ensure proper insulation and adequate ventilation. Do not use this model with electrical voltage unless you are a certified professional.
• No Warranty: I cannot guarantee the mechanical strength or dimensional accuracy of the print, as 3D printing results vary significantly depending on the printer, calibration, and individual settings.