Shaker Table

This shaker table can be used as a school activity where kids build a tower using spaghetti and marshmellows to build a tower and then they can test their creation on the shaker table.  This build requires two bearings that are 8mmx22mmx7mm.  Here is the Amazon link.

https://www.amazon.com/dp/B07H83VV6B?ref=ppx_yo2ov_dt_b_fed_asin_title

Priniting instructions:

The half circle pieces on plate 2, need supports, I set it to normal supports.

The center shaft, plate 3 needs to be printed with supports.  I set it for normal supports.

The pins, plate 8, may need a brim set to outer brim.  I also found that printing them on a slower speed gave me better results.  On the Bambu printers I set it to silent and it gave me great results.

The bushings, plate 7, was printed with PETG, the rest of the build plates was all done in PLA.  You could use PLA if you wanted but in my experience it is not as strong and should last longer.

Here is a link to the YouTube Video I created to help with the assembly of the table.