Search models, users, collections, and posts
Bio
Average awesome homeschooled highschooler who likes basketball, math/engineering, and 3d printing with my P1S.
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Share
0
0
0
great model, extremely sturdy. I scald mine up a bit and will be printing several more
Share
0
0
0
one of the supports is stuck in there and I think the model would do better scaled down. will definitely print again cause it seems like a great model.
Share
0
0
0
Good design, the detail on the side printed well even when scaled down to 6in tall at 0.16 layer height
Share
0
0
0
#Troubleshooting
Please help! I recently got some Flexible PLA filament from FlashForge(as far as I know its just TPU) and after several failed Benchys due to the wrong max flow rate it has started printing fine accept for small blobs at the end of every layer. The filament is dry and i know the problem has something to do with my filament profile/slicer settings. Any Help would be appreciated. Thanks
Share
1
6
0
Please help! I recently got some Flexible PLA filament from FlashForge(as far as I know its just TPU) and after several failed Benchys due to the wrong max flow rate it has started printing fine accept for small blobs at the end of every layer. The filament is dry and i know the problem has something to do with my filament profile/slicer settings. Any Help would be appreciated. Thanks
Share
2
8
0
Share
0
0
0
printed great but the slots are to small for my rechargeable AA’s so I’m going to have to print a different. please make the holes bigger.
Share
0
0
0
Share
0
0
0
I printed the 101% and it was pretty tight but snapped in with some pressure. great model
Share
0
0
0
No more data