Parametric Drip Tray

This is an upgrade to my previous plant pot drip tray model to make it fully parameterized. In essence, this drip tray is a disc with five concentric ridges and channels cut between them to let water collect and evaporate evenly. almost all dimensions of the model are customizable, except for the bottom thickness and the number of concentric ridges. If you'd like to customize the model to your liking see the below list of parameters that can be tweaked:

• overall_diameter
  • this one's self explanatory - the overall width of the circular drip tray
• inner ridge width
  • the width in mm of the four internal ridges
• outer ridge width
  • the width in mm of the outermost lip of the drip tray
• ridge spacing
  • the width in mm of the space between each of the five concentric ridges
• channel_width
  • the width in mm of the channels cut through each internal ridge
• overall height
  • the overall height of the model, including the constant 2.5mm bottom thickness, so use this to change the depth of the ridges
• inner_ridge_offset
  • the difference in height in mm between the internal ridges and the outer lip of the tray
  • increase this to get a taller outer ridge relative to the inner ridges, but don't forget to increase the overall height as well, since this effectively pushes down the internal ridges from the overall height

This screenshot shows the default values of the above parameters in the uploaded profile: