158Splatter

cover

plate_1.png

BaschDE

PXL_20251227_203456339.jpg

PXL_20251227_203506841.jpg

PXL_20251227_203514516.jpg

PXL_20251227_203528030.jpg

Hab hier mal mein Druckprofil.&nbsp;Die Aussparung benötigt natürlich Stützen, diese lassen sich etwas schwer rausdrücken, klappt aber.&nbsp;Durch die starken Rundungen würde es natürlich in feinerer Schichthöhe besser, aber die Druckzeit steigt enorm.Für einen Controllerständer reicht 0,2 föllig aus, meiner Meinung nach.

Here's my print profile&nbsp;The recess naturally requires supports; these are a bit difficult to remove, but it works&nbsp;Due to the strong curves, it would naturally look better with a finer layer height, but the print time increases enormouslyFor a controller stand, 0.2mm is perfectly sufficient, in my opinion

0.2mm layer, 2 walls, 15% infill

https://www.printables.com/model/488659-minimalistic-nintendo-switch-pro-controller-stand-

Very similar to the 8bitdo controller stand I remixed, on this one I just removed a large chunk of the stand that is not needed to save on filament. Hope you find it of good use :)

Nintendo Switch Pro Controller Stand

ASIA

Print Profile(1)

Description

Comment & Rating (1)

This remix is based on

License

Related Models