Great quick test for your AMS!

Great idea for when you're towards the end of the spool and wanna get rid of it.

Printed fine, but does not fit similar Anker 737 "style" powerbanks, so only use this profile if you're going to use it for your specific power bank

Printed wonderfully, wish it was easier to access the drawers someway.

I've printed this 3 times - 2 with the full AMS and 1 at the small scale in a single color. Supports are a pain to remove (it's hard to get the supports that are behind the cape). I may try it again at some point and tinker with the support settings but it's a lot of filament, poop and time.

Took a little effort in seperating, but love the fact that it prints all in one. Fits my Alex drawer amazingly!

take care when removing supports

great design, also scaled up amazingly!

Be careful when removing supports, shoulder plate got knocked off