Hi, does anyone else experience flow rate issues after last night's Cloudflare outage? Due to the Cloudflare problem, the print transfer was incomplete and got stuck overnight. I ended up turning off the machine and restarting it to delete the pending prints. But now, I'm facing flow rate issues again.(Edited)

Hi, I’m using a P1S and I’m having a severe problem. Do you have any idea how to fix it? I bought the machine on September 11th. --- (edit @2025-11-06) *Thank you all for your comments!* First of all, the filament didn’t absorb any moisture — I replace it with a new one every week. The issue appeared out of nowhere, and since I was using the same print settings as usual, I couldn’t figure out the cause. As some of you suggested, I checked the nozzle, but it wasn’t clogged or dirty at all. The strange thing was that the toolhead suddenly got really loud, and the extrusion became unstable. Even when printing something simple like a square, the edges wouldn’t print properly — kind of like asphalt bulging in the middle. You could probably see that in the flow rate calibration pattern too. I tried calibrating three or four times, but it didn’t fix the problem. Then I noticed some canceling noise during the calibration process, so I tried running it again late at night when everything was completely quiet. I even pulled the printer out a bit from the corner to prevent sound reflections. And just like that — the problem disappeared! I think moving the printer from my desk to the floor might have been one of the main causes. I’d read that Bambu Lab printers usually don’t need recalibration after being moved, so I didn’t think much of it — but I guess mine was a special case. Anyway, thanks again for all the comments! You all gave me lots of useful hints, so if something like this happens again, I’ll definitely come back here to figure it out together.(Edited)