this printer great! I don’t mind having to glue it because it spins so nicely.

This has been a wonderful addition! The ability to pose the wings is a great plus!

the cross brace was a needed touch. thank you for adding that!

The last section of the tail didn’t print properly and fell off, but thank you for sharing the model.

this was a great gift for someone & they loved every minute of opening it up!

this printed out great! the guidelines on how to start using the puzzle after the print were spot-on.

These worked great if the filament was being stored outside of an AMS. I had a spool unwind on me when the AMS was rotating the spool while drying it.

Printed great! I used a pair of needle nose players to gently pivot the planetary gears which helped loosen up the spinning mechanism.

I appreciated the notes about trying the different sizes. I would like to mention that if you can get a ruler and measure the diameter of the spool, that should help you decide which one you need to print. I also found that these rings only work with PLA spools and not PETG-CF or ABS.