Turned out great!

Nice print!

They work perfect and fit inside my case nicely!

This is a fun print. I glued some of these HF ceramic block magnets to the back: https://www.harborfreight.com/hardware/magnets/2-piece-craft-magnet-blocks-98406.html They stick on both sides so they hold the sockets into the print while also sticking to work center on my US General toolbox.

Thanks! I was hoping this would fit my Doyle 5” precision flush cutter but it was too small. I modified the 2nd time around and now it’s fits perfectly!

Love it! Great quality print in ABS. I plan to print one for each of my vehicles.

great print. I’m surprised at how nice it is without supports!

Perfect fit for the Bambu swatches. I printed the larger version so I can print swatches of some of my other filaments.

Looks great!

This is an excellent print for EDC. The original textured file was quite small as you can see in the comparison pic. Therefore, I resized it to fit the P1S print bed and now it’s perfect for my guys edc. He’s using the smaller one to toss remotes in.

Perfect fit in my Bronco. screw sizes mentioned are also dead on! I added the bucking Bronco logo and they turned out nice!

excellent print!

This print turned out very nice. I highly recommend!

Excellent print! It looks just like the Bambu spools!

Fast print. I just need to grab some glue!!

I have a 2003 Jeep Wrangler Rubicon and the center console tub was busted out. this replacement works perfectly!!! Thank you so much for the print!

Great print! This was my first time printing with abs and I love how they turned out. The lids snap into place which is quite satisfying and when you pull the device out of the ams there’s no chance of spilling. very well thought out! I will definitely print again if I add another ams! pic taken immediately after installing. it’s 50% humidity in my house and already reduced to the 35 in pic. still reducing as I post!