Rack-It

Version 2, out now!

I've spent some time using my own design and have found some areas of improvement. These areas are below

1. The rotation of the bracket was always an annoyance to me as it might slide over time. To fix this, V2 re-works all the brackets to add a corner piece to the end of it. This will help it “clip” onto the rack and prevent it from rotating.
2. The print profiles are now separated between attachments, imperial brackets, and metric brackets. 
3. The supports have been adjusted in the attempt to make them easier to remove.
4. Finally, I've added a new 2" peg sleeve that you can use to hold clips on your Rack-It bracket. 
   1. We do not recommend placing actual weight on this. Use it at your own risk.

---

Introducing “Rack-It”: Customize Your Power Rack

Tired of cluttered gym floors and constantly searching for your phone and water bottle? The Rack-It System is here to revolutionize your power rack experience!

What is Rack-It?

Rack-It is a versatile system of brackets and attachments that seamlessly integrates with your existing power or squat rack (depending on supported sizes).

Key Features:

• Modular Design: Choose from multiple bracket sizes to fit your specific rack dimensions. Supported sizes:
  • 2" x 2" (1" pole)
  • 3" x 3" (1" pole)
  • 3" x 3" (5/8" pole)
  • 3" x 2" (1" pole)
  • 3" x 2" (5/8" pole)
  • 70mm x 70mm (21mm pole)
  • 72mm x 72mm (21mm pole)
  • 62mm x 62mm (25mm pole)
  • 60mm x 60mm (20mm pole)
  • 60mm x 60mm (14mm pole)
• Essential Attachments: Use the provided basic models for the following:
  • Phone holder with cutout (95mm)
    • The cutout is 73mm and is so you can still use your phone screen while it's in it.
      • Small phones beware!
  • Cup holder (92mm)
    • Intended for a hydro-flask 40oz
  • 2" Olympic Barbell Pin
    • Intended to be used as a holding spot for your barbell clips.
    • We do not recommend placing actual weight plates on it. Use it at your own risk.
• Further Creativity: Utilize the "Slider Plate" to design and create your own custom attachments.

How it Works:

1. Select Brackets: Choose the appropriate bracket size to match your power rack's profile.
2. Add Attachments: Easily attach pre-made accessories like cup holders and phone holders utilizing the slider joint design.
3. Get Creative: Design and 3D print your own attachments. Use the Slider Plate to effortlessly integrate them into the Rack-It system.

Notes:

• We've so far had good results printing in PLA. (Personally I used bambu PLA matte)