Heavy Duty Hook (Car Ramp & JackStands)
Copyright Claim
Heavy Duty Hook (Car Ramp & JackStands)
Boost
9
21
9
Print Profile(2)
PETG / 0.2mm layer, 7 walls, 30% infill
Designer
1.3 h
1 plate
ASA / 0.2mm layer, 7 walls, 30% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
9
21
9
1
44
50
Released
Description
I created this for my specific jack stands, but they also work with my ramps.
It should work for various other heavier items.
These were printed in PETG with 7 walls, 4 top and bottom layers, and 30% infill. While this is probably overkill, I'd rather play it safe.
Comment & Rating (9)
All
看起来很不错的内容，用炭纤维打的话强度怎么样啊
The designer has replied
0
Reply
Thank you. I'm sure strength would be fine using carbon fiber filament if you orientated it to print on it's side. The issue with carbon fiber is usually layer adhesion.
0
Reply
Print Profile
PETG / 0.2mm layer, 7 walls, 30% infill
I suppose that turning 40 makes you being excited about printing personalised hooks, but I printed 3 of those and they hold perfectly the 3 steps ladder I printed them for. I will certainly reprint many.
1
Reply
Print Profile
PETG / 0.2mm layer, 7 walls, 30% infill
all good , remix to make mount shorter
0
Reply
Boosted
Print Profile
PETG / 0.2mm layer, 7 walls, 30% infill
Works great
0
Reply
Print Profile
PETG / 0.2mm layer, 7 walls, 30% infill
1
Reply
Print Profile
PETG / 0.2mm layer, 7 walls, 30% infill
0
Reply
Print Profile
PETG / 0.2mm layer, 7 walls, 30% infill
0
Reply
Print Profile
PETG / 0.2mm layer, 7 walls, 30% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld