Ikea Skadis - Instax Dual Photo Holder
Print Profile(4)
Description
Boost Me (for free)
If you like this model and want to see more, please drop a boost! It's greatly appreciated as many hours go into my designs and lots of failed prints! Thank you! :)
My design allows you to easily mount and display your physical instax and polaroid photos on your IKEA SKADIS Pegboard.
This is the “DUAL” version of my design which allows you to display photos on the top and bottom at once.
Note:
- I recommend adding the photos first before placing the holder onto the pegboard.
- Slide the photos from left to right / right to left one by one
The design allows you to freely move the photos within the peg hole so you can display in all directions (left, right, up, down):
There are four print profiles for different lengths.
- 30mm (Two instax photos / Top and Bottom)
- 60mm (Two instax photos / Top and Bottom)
- 254mm (Eight instax photos / Top and Bottom)
- 340mm (Twelve instax photos / Top and Bottom - covers half of the IKEA SKADIS Board - 9 Holes)
I recommend using the print profiles as this design requires supports. I found this profile to perform the best after numerous failed attempts.
If you are looking for a single photo holder design, check out my other model here:
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (12)