Tool for V5 AMS Savers (under 15min pint)

Want to save time and cut your PTFE tubing fast while your AMS 1 Saver Snag Cutter V5.0  or  AMS 2 Pro Saver Snag Cutter V5.0 (by Hexavalent) is printing?  
Well have I got the tool for you!

Print this handy multi-tool on another printer while you wait and get started on cutting your tubing quick. 
Perfect for print farms that need to get their tubing cut quickly.
 

Steps:
1. Insert the tube and cut at the 5mm then 50mm slots to cut your PTFE tube to length by holding the retention tab down and cutting with your blade of choice.
To cut the 5mm tube there is a small recess at the end of the retention tab.
To cut the 50mm tube push it to the end and cut at the further slot, to remove the tube use your thumb to slide the tube out along the side slot.

Tip: You can even use the Bambu Labs cutter you'll be using on the AMS Saver. 

2. Use the tool to grab the 5mm tube and insert it slightly into the base of the AMS saver. Then use the flat portion of the tool to press the tube all the way into the AMS saver.

3. And finally, use the clamping portion of the tube to put the 50mm tube into the top of the AMS Saver. 

Special feature!
Insert a section of filament up to the small tube notch and cut it at the outer slot.
Insert the filament piece into a small hole in the middle of the outer slot and use this to remove the upper retainer of the AMS Saver.

And there you have it, a tool to help you install all four of your AMS Savers to prevent those pesky tape stoppages. 

PS. Bill of materials items are optional if you already have tubing & blades.