Basic Turntable *UPDATED* by AngelicAnarchy

AngelicAnarchy

Tools>Other Tools

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 10% infill **Updated More Round

Designer

13.1 h

4 plates

4.8(19)

Boost

167

230

191

Released

Description

A simple 2-piece turntable to be used for whatever you need. Frosting a cake? Painting an object? Dead simple, does what it needs to do. Print from PLA Marble for a stunning kitchen piece or whatever leftover green/orange filament you have because it will get covered in paint anyway. Easily add a design into the top surface with a remix for any fun kitchen designs.

Clearance is 0.4mm in the model. A little sanding up to 320 grit will make it super smooth and spin very freely. Consider increasing infill in the base section if you want it heavier.

**Update 01/01/24:

-Added STEP files to raw model files. Replaced Print Profile with STL version. This makes the parts substantially more round, not comprised of a visible number of straight line segments around the perimeter.

-Added Spiral and Concentric Circles variants!

Comment & Rating (21)

@mattgrfn

Print Profile

0.2mm layer, 3 walls, 10% infill **Updated More Round

Really easy to print and the size is great!

@Gerxi01

Print Profile

0.2mm layer, 3 walls, 10% infill **Updated More Round

Top zum Airbrushen

@DarkEnergyLab

Boosted

Really easy and helpful print. Works great, Thanks!!!

@svgPhoenix

Print Profile

0.2mm layer, 3 walls, 10% infill **Updated More Round

works really well. best turntable I was able to find that didn't need bearings or a motor

@korndog

Print Profile

0.2mm layer, 3 walls, 10% infill **Updated More Round

printed perfect

@Hoju

Print Profile

0.2mm layer, 3 walls, 10% infill **Updated More Round

Does exactly what it needs to do. Accidentally did 20% infill on top so it took longer but feels pretty solid.

@user_4040136516

Works fine

@Clansman

Print Profile

0.2mm layer, 3 walls, 10% infill **Updated More Round

Spot on profile, i had no issues with this, print came out lovely.

@thetonestarr

Print Profile

0.2mm layer, 3 walls, 10% infill **Updated More Round

works perfectly!

@TJSlayer

Print Profile

0.2mm layer, 3 walls, 10% infill **Updated More Round

Works well but perhaps a bit large for the bed, had slight issue with the part on the front of bed, so if I were to print again likely do at 95%. Will work as is for what I intended. but the purge line ended up messing up that little bit.