Fishing Frog Tea Bag Holder

Fishing Frog Tea Bag Holder

Boost
43
78
3
GIF

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

4 Colors, 0.2mm layer, 3 walls, 15% infill4
4 Colors, 0.2mm layer, 3 walls, 15% infill4
Designer
1.7 h
1 plate
4.7(3)

3 Colors, 0.2mm layer, 3 walls, 15% infill
3 Colors, 0.2mm layer, 3 walls, 15% infill
Designer
1.5 h
1 plate

Boost
43
78
3
0
52
30
Released

Description

This frog not only holds the tea bag when brewing, but also holds the used tea bag in his bucket/basket which allows it to dry out before dropping into trash bin and therefore reduce trash water content that promotes bacteria growth.

 

Easily print with PETG without support. Can be printed in single color or multi-color. Colors are set by height range and thus has limited number of filament swaps. Two print profiles for multi-color printing are provided, one for 4 colors and the other for 3 colors. See profile photos for detail.

 

No assembly is needed.

 

 

It’s simple to use. See the GIF animation (video can be grainy due to high compression to reduce file size). But here’s the instruction: Pull the tea bag string over the notch at end of the fishing rod, down and slightly towards you, then pull the string through the cut notch on the reel. If one finds it not easy to do that then try this: touching the paper tag at the upper part of frog’s belly as shown in the GIF, as doing that mostly will get the string inside the cut notch on the reel. Then let the bag pull the string back naturally and keep the paper tag slide along the frog’s hand, as shown in the GIF. When it gets to the point between frog’s fingers and the reel, push the paper tag up into the space between them.

 

Check out my other kitchen designs:

 

Yin Yang Tea Bag Organizer Tray

 

Snap-on Hands-Free Can Strainer

 

Rinser for Tall Glass/Bottle/Flask/Thermos

 

 

 

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Print Profile
4 Colors, 0.2mm layer, 3 walls, 15% infill4
0
Reply
Print Profile
4 Colors, 0.2mm layer, 3 walls, 15% infill4
0
Reply
Print Profile
4 Colors, 0.2mm layer, 3 walls, 15% infill4
0
Reply
No more

License

This work is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.