Oreo AirTag Holder / Keychain
Remixed by
Boost
149
246
70
Print Profile(3)
Standard Two Color Print
Designer
2.2 h
1 plate
V2, 0.2mm layer, 2 walls, 15% infill
1.4 h
2 plates
0.2mm layer, 3 walls, 15% infill
2.4 h
1 plate
Open in Bambu Studio
Boost
149
246
70
19
480
455
Released
Description
Keychain screws together to hold an Airtag, new file for multi-material printer with thicker keychain loop!
Comment & Rating (70)
All
..for the girls :)) ..after removing support (exhausting matter) it looks very good !! It's worth it ;-)
3
Reply
Prints great in PETG. Cleaning up the supports is a PITA… but after cleanup looks perfect. Smooth and when closed, feels like one solid piece with the AirTag inside.
1
Reply
Print Profile
Standard Two Color Print
Perfect profile! Cheers!
1
Reply
Print Profile
Standard Two Color Print
very nice fits Apple AirTag nicely 5 stars for me too give to my Daughter.
(Edited)
0
Reply
Print Profile
Standard Two Color Print
Great design. Works great. Had to replace the white PTG with transparent. Many thanks for the model.
0
Reply
Print Profile
Standard Two Color Print
hat super funktioniert
0
Reply
Print Profile
V2, 0.2mm layer, 2 walls, 15% infill
super print!! It took me a lot to remove the supports but the result is 10
0
Reply
Print Profile
Standard Two Color Print
Came out very nice with Bambu PLA Matte. A bit of annoying supports but a few minutes with some tweezers and it was done.
0
Reply
Print Profile
V2, 0.2mm layer, 2 walls, 15% infill
top
0
Reply
Awesome print!
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld