toothpick dispenser
Copyright Claim
toothpick dispenser
Boost
75
111
28
GIF
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
4 h
2 plates
with logo bambulab
Designer
1.4 h
2 plates
Open in Bambu Studio
Boost
75
111
28
1
262
141
Released
Description
Practical, lift and take toothpick dispenser. one at a time, without the annoying succession of others that promptly fall to the ground.
Simply designed, reminiscent of a similar contraption I had many years ago.
available in the version with hollowed out logo and any subsequent additions with glue, or simply plain without logo.
the writing on the cover can be easily printed even without ams by setting the right pauses, or simply printed in one colour.
hope you like it...
rate it!
Comment & Rating (28)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Beautiful design but not perfect, sometimes it pick up more than one and sometimes it get stuck
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect
The designer has replied
1
Reply
10ks for rating
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
my new friend in the kitchen. thanks for sharing
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works well, but could be a bit more tight
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:I really like the model, but I think the lid needs to snap in because it easily comes off when grabbing a toothpick. It easily fit all my toothpicks.
1
Reply
Flawed design... It has to be filled quite a bit to work... and even then, it doesn't work flawlessly... Take more time to get the toothpick from the device than from a simple tube.
The designer has replied
1
Reply
fa trazione quando alzi la.parte esterna, giusto? se così, ruota la parte esterna di 180 gradi altrimenti risulta poco scorrevole. ha un suo senso corretto di inserimento. mi sono appena reso conto di non averlo messo in descrizione.
0
Reply
Could you please tell me which profile you printed? because if you printed the profile that was deleted it was completely devoid of corrections for optimal printing.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very clean print
(Edited)The designer has replied
1
Reply
grazie
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Does not work properly despite the suggestions for thinner sticks
The designer has replied
0
Reply
pull out the outer part and rotate it 180 degrees. has its own precise insertion direction.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very good!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
funktioniert hervorragend
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld