Quick Clamp - Free 3D Print Model

Search models, users, collections, and posts

LoboCNC

Tools>Other Tools

IP Report

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 4 walls, 30% infill (Author's Spec)

2.6 h

1 plate

4.7(27)

0.2mm layer, 5 walls, 50% infill

4.2 h

1 plate

4.8(9)

Open in Bambu Studio

Boost

120

277

400

224

Released

Description

This 110mm light-duty clamp uses a quick-adjusting rack & pinion to open and close the clamp, and a spring-release ratchet to hold the clamp shut. It prints with minimal supports and requires no additional fasteners.

Print Settings

Printer:

UDIO

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2mm

Infill:

30% (triangular)

Notes:

Print with 4 perimeter lines (0.4mm wide) for greater strength and stiffness. Print two of the pad parts and one each of the body, jaw, gear and pawl.

Post-Printing=============

After printing, sand down any blobs or lumps on any of the mating surfaces. Using a little Vaseline or light grease on the moving parts will make it operate more smoothly. To assemble, first insert the pawl into the hole in the side of the moving jaw. Then insert the gear into the key-hole shaped slot in the jaw and slide it up towards the pawl. Then slide the moving jaw onto the body. Finally, slide the pads into the dovetail slots on the jaws. Rotate the knob CCW to clamp, press the release lever and rotate the knob CW to unclamp.

Category: Hand Tools

clamp

thingiverse

clamps