Clamp
Copyright Claim
Clamp
Boost
16
24
9
Print Profile(1)
0.16mm layer, 4 walls, 50% infill
3.3 h
1 plate
Open in Bambu Studio
Boost
16
24
9
0
55
23
Released
Description
Clamp
Comment & Rating (9)
All
Orca Slicer split the file into objects, all parts now lay flat on the bed. Test print in PLA, slow speed. Threads are too tight. I used M10 x 1.5 tap to clean out the hole in the small bar, M6 x 1.0 tap to clean out the hole in the treaded handle. The foot screwing into the bottom of the handle should be a ball joint. The angle is too large/too much movement in the bar.
0
Reply
Print Profile
0.16mm layer, 4 walls, 50% infill
Good strength, but one piece prints terribly, threads are not proper. Generally too tight of a fit to be usable
1
Reply
Print Profile
0.16mm layer, 4 walls, 50% infill
Die Schrauben gehen nicht ineinander!
und bei drück bricht man es natürlich.
The designer has replied
0
Reply
Y no la puede editar para modificar?
0
Reply
Print Profile
0.16mm layer, 4 walls, 50% infill
Bolt too tight
0
Reply
Print Profile
0.16mm layer, 4 walls, 50% infill
The designer has replied
0
Reply
En que basa su baja calificación?
Yo solo subí un perfil de impresión y creo que se imprime correctamente.
Otra cosa es que no le sea útil el producto.
Creo que su criterio está desorientado.
0
Reply
Your product is very onteresting! But one part starts printing to the air in the middle of process and it ends with spagetti effect. I tried to print it twice. It ended the same in both cases. The part that I marked has no first layer. But I have printed it from cellphone not from computer so I did not change any set-ups…
0
Reply
Print Profile
0.16mm layer, 4 walls, 50% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld