Standing Clicker Counter

A fidgety clicker counter for any game that can use a counter between 00 and 99. Simple print and assembly, satisfying clicks! It is made to be able to be used in one hand. This is an evolution of this design https://makerworld.com/en/models/687026#profileId-615728

Print profile includes all cover options including Blank. Just print the plates with what you want.

The body and dials are PLA.
The spring works as PLA, but will get less stiff as time goes on. This may be good, depending on your preference of how much resistance you prefer.

The spring can also be printed in PETG, which does not get less stiff over time. Over dozens of prints, I've found PLA to be adequate, but your settings or PLA material may perform differently than mine.
 

The cover is press-fit. Check your X-Y hole compensation if the fit is not snug. You may superglue the posts of the cover into the holes to make the case more rigid.