Coffee Clip V2
Copyright Claim
Coffee Clip V2
Boost
45
89
40
Print Profile(3)
PLA 0.2mm / 2w / 15%
Designer
3 h
2 plates
ABS 02.mm / 2w /15%
Designer
3 h
2 plates
A1 Mini 0.16mm layer, 2 walls, 15% infill
3.3 h
2 plates
Open in Bambu Studio
Boost
45
89
40
12
158
230
Released
Description
A new version of my coffee bag clips. This one only needs one screw (3x12mm) the rest is print in place.
There is a test print plate so that you can print just the hinge, if that works everything else will be OK.
You will get a warning about there being floating regions, ignore this it's the print in place hinge.
Comment & Rating (40)
All
Print Profile
PLA 0.2mm / 2w / 15%
works absolutely fine. the look is great. thx
1
Reply
Print Profile
PLA 0.2mm / 2w / 15%
no problems with print. Made two instances and both work very well. But be careful as some coffee bags are much wider (like Lavazza) and this bag clip could be too small for it.
I used similar bag clip for coffee before, but this one is improved since its inner ring locks and doesn't spin when you try to tighten the cap. And it also includes multicolor version which looks nicer ;)
The designer has replied
0
Reply
I really thought the bags were the same size. I find it works better if you only cut the top 1/3 and leave the rest sealed.
0
Reply
Print Profile
PLA 0.2mm / 2w / 15%
In my opinion, this is better design than Miele's old design. 👍
The designer has replied
0
Reply
Thank you, I really like the miele design but found it had a bit too much clearance and the bag would slip out.
(Edited)0
Reply
Gedruckt in ABS 👍
Funktioniert sehr gut.
The designer has replied
0
Reply
Ich danke Ihnen vielmals.
1
Reply
Perfect! PETG
0
Reply
works fine, tnx
0
Reply
Print Profile
PLA 0.2mm / 2w / 15%
Perfect!
thanks for Sharing your file!
0
Reply
Looks very like Miele's design.
The designer has replied
0
Reply
It does, but the miele design was done years ago for printers that aren't as accurate are we have today. I found it didn't grip the bag tight enough.
(Edited)0
Reply
Boosted
Print Profile
PLA 0.2mm / 2w / 15%
Just Printed Looks great now to see how well it works!
0
Reply
Boosted
Great design!
Love these structured outer walls
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld