arduino dupont wire stack organizer
Copyright Claim
arduino dupont wire stack organizer
Boost
8
31
2
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
2.9 h
2 plates
Open in Bambu Studio
Boost
8
31
2
0
35
12
Released
Description
just simple wire stack. smaller for 10cm ones, bigger for 20cm.
Print Settings
Printer:
ender 3
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0,2
Infill:
100
Filament: miroluk pla
Notes:
simple stack for your wires.
Post-Printing
Category: Electronics
Comment & Rating (2)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
I can finally organize my wires! However, the gap in the middle is a little bit too wide, so the wires at the top are not firmly locked. Thus, I have to be careful when putting the wires in and out, otherwise they get tangled.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
was very hard to get the wires out.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld