Silica Gel for filament spools (with flange) - no more fall and destroy for silica containers!
Remixed by
Copyright Claim
Silica Gel for filament spools (with flange) - no more fall and destroy for silica containers!
Remixed by
Boost
18
22
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.5 h
1 plate
Open in Bambu Studio
Boost
18
22
7
0
58
45
Released
Description
Every time I take a spool I forget about the silica container inside, it falls, explodes and all the silica is on the floor!
Stop wasting your silica gel on the floor!
This model can be printed without supports, I think petg will be better, but PLA is also ok.
I tested it on Eryone spools and Prusament, you wil find 2 files: the 56 is for Eryone, the 65 for Prusa (but can be used on Eryone and other spools)
the “HIRES” files have a better resolution
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect design, thanks for sharing, fits perfectly and puts a bit of extra weight on the spools in the prusa box, so they don't lift off that easily 👍
0
Reply
all around the quickest to print and least likely silica holder to leak broken beads in AMS. cap can get stuck if you tighten it, I use silicone lubricant on threads.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld