Search models, users, collections, and posts
Multicolor Dice (no AMS needed)
Remixed by
IP Report
GIF
Print Profile(2)
0.16mm layer, 1 walls, 100% infill
Designer
38 min
1 plate
Plain version - rounded corners - 0.08mm layer, 100% infill
Designer
44 min
1 plate
Open in Bambu Studio
Boost
20
44
6
1
68
37
Released
Description
Every multicolor dice I found required lots of material changes, resulting in a lot of waste for such a small item.
So I designed this one where each side is printed separately, needing only one material change(can even be done manually, without the AMS) for the whole dice.
The sides snap to the core keeping them in place. I added a bit of glue, but it is not needed.
There is also a version with the graphics inspired from the knucklebones minigame from Cult of the Lamb: https://makerworld.com/en/models/915497
I've been printing them in PLA and it gives a good bounce to them.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (6)