Blastoise - Pokemon
Copyright Claim
Blastoise - Pokemon
Boost
230
401
101
Print Profile(3)
0.16mm layer, 2 walls, 15% infill
Designer
3.2 h
1 plate
55mm high, 0.2mm layer, 4 walls, 10% infill
2.4 h
1 plate
0.16mm PLA
2.2 h
1 plate
Boost
230
401
101
2
992
741
Released
Comment & Rating (101)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Nice model! Print came out quite nice. A few spots on the underside could be smoother, but only noticeable if you look at the bottom.
The designer has replied
0
Reply
Unfortunately It is still FDM printer :/ It will always have some scars from overhangs. :( But when some scar is bigger, I sand it.
0
Reply
Replying to @phyXoo
Thanks! Yeah, it's really minor, and not a problem with the model. Still 5 stars, for sure.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
like the model, but had some issues with the supports
The designer has replied
0
Reply
first rule of removing supports. remove after cooling it off.
0
Reply
Print Profile
55mm high, 0.2mm layer, 4 walls, 10% infill
printed well!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Quelques petits fils d’ange, très certainement dû à mes réglages pas encore optimal. Cela fait trois jours que j’ai mon imprimante. Je suis super content du résultat.
0
Reply
après nettoyage il est mieux
0
Reply
Print Profile
55mm high, 0.2mm layer, 4 walls, 10% infill
nice
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Very good quality, my only issue with it being string lines on the bottoms
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
nice Print
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Awesome model, good quality.
(Edited)
0
Reply
Print Profile
0.16mm PLA
Nice design!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
works very well, thanks for sharing :)
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld