FILE IS READY TO PRINT

I UPLOADED 2 PRINT PROFILES, CHOOSE WITH OR WITHOUT FRAME

I USED BLUE SILK FROM BAMBU FOR THIS PROJECT

Project: BLASTOOOOO FRAME.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 153.53x220mm in size

You may print at higher layer heights below the Min Depth of 0.24mm

The Max Depth is 2mm and the Actual Depth is 2mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Matte Marine Blue Transmission Distance: 0.5

PLA BambuLab Matte Ash Gray Transmission Distance: 1.5

PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 4 unique filaments

Swap Instructions:

Start with Black

At layer #10 (0.88mm) swap to Marine Blue

At layer #14 (1.2mm) swap to Ash Gray

At layer #19 (1.6mm) swap to Jade White for the rest.

Reminder:

My models mostly cover the entire bed,
this means the purge line is sometimes
running through the bottom of the print.
You have 3 options here:
- Leave as is, you can just cut them of afterwards.
- Remove immediately after the purge line is printed.
- Scale the model:

*** WARNING ***
WHEN SCALING THE MODEL, BE SURE TO NOT SCALE THE Z-HEIGHT!
The Z-height must always be as original, otherwise the print
is messed up.

If u want to support my work

https://www.paypal.com/paypalme/MarcoMaineri?locale.x=it_IT

For request send me dm