CHARIZARD' S LEGACY HUEFORGE POKEMON FINAL by giamma933

giamma933

Art>2D Art

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

HUEFORGE WITH FRAME

Designer

3.9 h

1 plate

5.0(5)

HUEFORGE WITHOUT FRAME

Designer

3.4 h

1 plate

4.6(5)

Boost

182

241

193

Released

Description

FILE IS READY TO PRINT

I UPLOADED 2 PRINT PROFILES, CHOOSE WITH OR WITHOUT FRAME

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size

You may print at higher layer heights below the Min Depth of 0.24mm

The Max Depth is 2mm and the Actual Depth is 2.1mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Red Transmission Distance: 4

PLA BambuLab Basic Orange Transmission Distance: 5

PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 4 unique filaments

Swap Instructions:

Start with Black

At layer #8 (0.72mm) swap to Red

At layer #14 (1.2mm) swap to Orange

Border Only Colors from here until the end.

At layer #18 (1.52mm) swap to Jade White for the rest.

Reminder:

My models mostly cover the entire bed,
this means the purge line is sometimes
running through the bottom of the print.
You have 3 options here:
- Leave as is, you can just cut them of afterwards.
- Remove immediately after the purge line is printed.
- Scale the model:

*** WARNING ***
WHEN SCALING THE MODEL, BE SURE TO NOT SCALE THE Z-HEIGHT!
The Z-height must always be as original, otherwise the print
is messed up.

If u want to support my work

https://www.paypal.com/paypalme/MarcoMaineri?locale.x=it_IT

For request send me dm

Comment & Rating (45)

@simonluebbert

Unfortunately, the profile without a frame is absolutely unusable. The print is so thin at the edges that you can't even get it off the build plate without causing damage. "You may print at higher layer heights below the Min Depth of 0.24mm" -> You HAVE TO. It would have been nice if this had been adjusted directly in the profile so that the print works without the user having to make their own adjustments. Still a very nice motif and I will print it again in an adjusted form.

The designer has replied

@giamma933

Thanks for constructive review…i would say that yes sure is thin but your problem was only the warping as i see…there are other people who print it and no problems…so i would love to help u and understand how can i do it better for u…write me we ll fix

@simonluebbert

Replying to @giamma933 :

There was no warping during printing, that only happened when removing it from the build plate because the edges are so thin. It's a mystery to me how this could work for other people 😅 I've done a lot of Hueforge prints, but I've never had anything like this. The total thickness of 2mm is absolutely fine, only the 0.24mm at the edges is in my opinion far too little.

@giamma933

Replying to @simonluebbert :

I have no idea why for some is ok for sone no…anyway i would love to do the best project…how u suggest to modify only edges? Cuz otherwise i should do a new project? btw i appreciate constructive review like yours