Makita charger wallmount
Copyright Claim
Makita charger wallmount
Boost
130
325
117
Print Profile(2)
0.2mm layer, 6 walls, 100% infill
Designer
1.2 h
1 plate
0.2mm layer, 6 walls, 100% infill
1.2 h
1 plate
Boost
130
325
117
21
583
679
Released
Description
A simple mount for the most common Makita charger.
Just remove the four rubber feet and press the charger down onto the pegs on the mount, simple as that.
Can be mounted in all directions due to being press fit.
Questions are welcome and please like, rate and share.
Comment & Rating (117)
All
Boosted
Print Profile
0.2mm layer, 6 walls, 100% infill
great print! Fitts perfect
The designer has replied
1
Reply
brilliant use of it 🙂
(Edited)1
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
I like this mount a lot. It seems there has been a tiny change to the layout of holes on the charger itself at some point.
Everything is positioned perfectly and fits very snugly, except I had to use the cut tool in BS to remove 1.5mm of depth (photo) from the mount for it to fit my charger model.
For reference, my charger is:
model: DC18RC
part number: 630714N3
serial: 1113###
(Edited)
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 100% infill
Working perfect, thank you!
0
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
top
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 100% infill
Great print file and nice model, thank you.
0
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
tolerances are a bit tight. had to slightly modify one clip. but I understand why.
0
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
Seems a little too large, but still fits
0
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
super geworden in PETG von Unger!
passt perfekt!!!
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 100% infill
super
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 100% infill
Works perfectly. Thank you
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld