Planetary gear spinner 55mm
Copyright Claim
Planetary gear spinner 55mm
Boost
53
94
43
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
53
94
43
0
330
312
Released
Description
Planetary gear spinner mini
Outer diameter 55 mm (2.17 inch).
Printing takes about 1 hour.
Comment & Rating (43)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
I printed these at 75% and they came out great. a little loosening up did the trick.
0
Reply
The print profile is no longer public
nice!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Print turned out well. Moves easily after the initial few rotations.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed without any problems, besides that my Filament ran out, but it has quite a nice Look to it now. This print is a great Stresstest for the printer because of very fast and small movements and because of Print in place a good tolerance Test too. Thank you for the Design
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed beautifully on the A1 mini! Fun design and simple! Small enough to keep in your pocket!
(Edited)
0
Reply
The print profile is no longer public
stuck at the beginning but after losen it and some WD40 it spins smoothly
The designer has replied
1
Reply
yea this is how most of them are. thanks for sharing this!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
curioso
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
kids love it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
well spin
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good stuff
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld