HSW Xiaomi Electric Precision Screwdriver Holder (Honeycomb Storage Wall)
Remixed by
Copyright Claim
HSW Xiaomi Electric Precision Screwdriver Holder (Honeycomb Storage Wall)
Remixed by
Boost
12
38
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
12
38
6
0
42
14
Released
Description
Please comment, rate, and post a make!
I really liked the holder design modifications done by FTBT, but it didn't quite fit the branded Xiaomi precision screwdriver (affiliate link) set. This is a revision, modelled from scratch to fit that case. Aside from resizing, this maintains the ability to grab the driver/bits without remove the case from the holder. It does require removing the outer portion of the case.
Will require two blank inserts to attach to the HSW.
Be sure to check out my other models!
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Sadly its a little tight for the driver. It fits. But hard to remove
The designer has replied
1
Reply
Noted, but the idea was that the case would be left there. I did check mine and while it's snug, I was able to remove the case relatively easily.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld