AMS Lite cover for Vertical mount mod 'no support'
Copyright Claim
AMS Lite cover for Vertical mount mod 'no support'
Boost
21
52
17
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
0.16mm layer, 2 walls, 15% infill
1.7 h
1 plate
Open in Bambu Studio
Boost
21
52
17
0
98
47
Released
Description
A quick cover for the AMS Lite mount after I installed the vertical stand. The numbers are printed on a separate plate and glued on. This is a slip fit and stays in place with no screws.
Comment & Rating (17)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Schönee Abdeckung. Sitzt etwas locker und wurde bei mir mit doppelseitigen Klebeband fixiert, damit sie beim Bewegen des AMS nicht abfällt.
(Edited)
The designer has replied
1
Reply
Vielen Dank für das Feedback. Ich werde sehen, ob ich die Toleranz ein wenig anpassen kann.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Fits good
The designer has replied
0
Reply
Perfect! Thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Passt nicht so ganz zur Silhouette der Aussparung aber hällt von alleine ohne Schrauben.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
thank you
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld