Search models, users, collections, and posts
Playstation Magnetic Blocks Stand
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
3.4 h
2 plates
Open in Bambu Studio
Boost
8
9
1
0
2
0
Released
Description
This is a 2 color stand for my previous Playstation Magnetic Blocks: https://makerworld.com/en/models/856122
Printed face down to limit filament changes and look the cleanest. I used tree supports, but they were a bit challenging to remove from the fastener openings. May want to try other supports or a support material if available.
Once cleaned out, insert the fasteners into the openings using plyers, carefull not break them. I added a second plate with just the fasteners and recommend printing with 100% infill.
Single color, embossed version: https://makerworld.com/en/models/866225
Separate 2 color logo plate version: https://makerworld.com/en/models/866256
Boost Me (for free)
Feel free to leave a boost if you find this model useful!
Documentation (1)
Assembly Guide (1)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)