BroomHolder V 2.0 "print in place"
Remixed by
BroomHolder V 2.0 "print in place"
Remixed by
Boost
13
37
2
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Boost
13
37
2
1
49
28
Released
Description
I adapted the great “Gravity Broom Holder”.
the original part is really great! But I wanted to prevent the wheel from getting lost.
- I closed the groove at the top.
- For more weight, up to 4x M4 nuts can be pressed into the wheel
It is very important that you use my profile or pay close attention to the support.
Material: Part PLA then support PETG or just swapped... this is important because the two materials do not stick together
Comment & Rating (2)
All
Printed great! I used Bambu PLA and Bambu PETG.
I found that my broom did not work well, when I added a small rubber band to the wheel/gear and that made it work perfectly.
A small recommendation is to include the wall screw prints as well
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld