A case I made styled after a case I had come across in the videogame Starfield. I had been thinking about this basic idea for awhile, but it was catching that design in starfield that kicked things into gear. I would like to do a version down the road that prints on end for the main case. As it is, it's styled to print flat, which can be tough on the curved nature of the model. I simplified it a little from the starfield version to make it more practical and easier to use/print/assemble.

There's 3 sizes provided! A Small, Medium, and Large! The Medium should work fine on most modern sized printers (with a 250ish bed). The large is sized for something like a 400mm sized bed! You can of course modify the files to fit whatever size you want. I'm going to make one I can fit a gridfinity setup in!

Hardware Required: 16 x M3x10mm screws to attach the ends. The hinge uses a piece of filament. You might need to use something to clear the hole a little, to get the filament in. It is sized just big enough. 4x6 magnets are used to keep the lid closed.

If you're looking for more of a specific recreation of the starfield case, check out this one by user @WonderBread_251991 https://www.printables.com/model/173175-starfield-chronograph-watch-case