Tiny Multicolor Jet Fighters - Print-in-place and Articulated
Copyright Claim
Tiny Multicolor Jet Fighters - Print-in-place and Articulated
Boost
333
521
43
Print Profile(5)
Blue Angels 100% scale. 0.16mm layer
Designer
14.2 h
1 plate
Jolly Rogers 100% scale - 0.16mm layer
Designer
17.3 h
1 plate
Jolly Rogers 200% scale. 0.2mm Layer Height
Designer
30 h
1 plate
Blue Angels 200% scale. 0.2mm Layer Height
Designer
25 h
1 plate
Click to see more
Boost
333
521
43
26
887
270
Released
Description
https://www.instagram.com/p/C0ZsZbDrwg0/
What if Blue Angels used F14?! Tiny 3d printable print-in-place and articulated f14 in colors inspired by the Blue Angles! The built in wingtip support breaks of with a satisfying snap and leaves a nice clean edge
Subscribe or follow me on:
Instagram: www.instagram.com/agepbiz
YouTube: www.youtube.com/user/agepbiz
Twitter: www.twitter.com/agepbiz
Printsettings:
No support
No raft
0,16mm layer height
Comment & Rating (43)
All
Superbe modèle par contre pas mal de problèmes à cette échelle. Pas mal de partie se sont cassés lorsque j’ai décollé les Support. Beaucoup de déchets pour quasiment très peu d’impression 90% à la poubelle ça fait quand beaucoup, dommage et surtout 17 heures c’est long. je le réimprimerai, mais cette fois en plus gros et sans multicolore.
4
Reply
what’s this tower for
0
Reply
your printer has to change the colors. So this tower to clear the heater
0
Reply
thanks
0
Reply
I’m new to 3d printing so I’m still figuring it out. Thank you for telling me what the tower is for :D
0
Reply
Print Profile
Jolly Rogers 200% scale. 0.2mm Layer Height
Small ones with multicolour did not work for me, so i printed the big one with single colour
2
Reply
Print Profile
Jolly Rogers 100% scale - 0.16mm layer
well done.
(Edited)
0
Reply
Boosted
Print Profile
Blue Angels 100% scale. 0.16mm layer
Fantastic Model, I knew the amount of waste was going to be stupid and while I could have probably printed 20+more planes with the waste. To have a F-14 in the blue Angles with functional wing sweep is to cool. The photos do not do them justice in how well they turned out.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Blue Angels 100% scale. 0.16mm layer
1
Reply
Print Profile
Blue Angels 100% scale. 0.16mm layer
0
Reply
Nice model but way too much waste! Print in place is awesome and great functionality but i could have printed 20 more with the pooped material swap outs! Beware - great model - but due to nature of Bambulab material swap - lots of wasted filament!
(Edited)2
Reply
Print Profile
Blue Angels 100% scale. 0.16mm layer
While these are really awesome. It can be difficult to get the wings to work. You just need to work the wings back and fourth until they move freely. A few times should do it. Don't try to move them fully at once. Also, prepare for a tremendous amount of purge poop for such tiny objects. Though, it's worth it
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld