Custom Beyblade X Bit - Low Gear Flat

This is the Low Gear Flat Bit, made by me this time! Its compatible with any Beyblade from the Beyblade X line.
Its literally Gear Flat… but smol.

Print with “Tree (Auto)” Supports, and keep Infill at 15%. There will be a bit of support on the inside part on the bottom (Where it is usually hollow) which you can remove with a small tool such as a toothpick.

I printed this with ELEGOO Basic PLA White, but it should work with most PLA filaments. Be advised as these are 3D printed parts, so they can get worn out faster than official products (They still hold up pretty well).

Drop some suggestions below on what Bit I should upload next! Maybe even some suggestions for custom Bits…

Also, sorry about the App Icon image, it might be inverted and I can't figure out why, probably just a glitch tho!