Xmas Tree Piston Launcher
Copyright Claim
Xmas Tree Piston Launcher
Boost
24
38
4
GIF
Print Profile(2)
0.28mm layer, 2 walls, 15% infill
Designer
4 h
2 plates
0.28mm layer, 2 walls, 15% infill
Designer
5.3 h
5 plates
Boost
24
38
4
0
43
48
Released
Description
Piston launcher, that can launch an xmas tree ;-)
Launch angle adjustable!
Things to take note:
- Do not enable support when printing the tree.
- Must use 0.28 layer height for the tree.
- You will need some effort to press the tube into its base. It is tight so can air seal better.
Comment & Rating (4)
All
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
(Edited)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld