Keycap Puller: Print-in-Place
Copyright Claim
Keycap Puller: Print-in-Place
Boost
14
20
2
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
16 min
1 plate
Boost
14
20
2
3
63
11
Released
Description
Keycap Puller: Print-in-Place
---------------------------------------------------------------------------------
About:
- Print-in-place keycap puller that safely removes keycaps from a mechanical keyboard
- Inspired by Nikoraasu's keycap puller
- Printed with NO supports, as the file has built-in supports
- Printed in less than 25 minutes on a standard MK3S
---------------------------------------------------------------------------------
Printing:
- Tested with PLA and PETG
- Disable supports
- Enable bridging
- 3 perimeters
- 15% infill
- 3mm brim recommended
---------------------------------------------------------------------------------
Post-Processing:
- To remove the built-in supports, I used a stiff thin board to slide between the two halves.
- Use clippers to remove the excess filament
---------------------------------------------------------------------------------
Design Process:
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue:It broke while removing the supports. I printed it with PETG.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld