Print Profile(2)
V2 0.16mm layer, 3 walls, 20% infill
Designer
1.4 h
1 plate
0.16mm layer, 3 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
7
26
11
0
89
38
Released
Description
A smaller case for the ESP8266 chip , i use this for my wled
Comment & Rating (11)
All
Print Profile
0.16mm layer, 3 walls, 15% infill
This case looks great and was exactly what I was looking for. It printed quickly and fits well. Thanks!
(Edited)
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Bed Adhesion Issue
The designer has replied
1
Reply
you cant blame my STL if your bed is dirty and cant get good bed Adhesion , i have printed a few of this and a lot of other people with out any problem
(Edited)0
Reply
Replying to @Rewilo
I’m not so sure it’s because the bed is dirty. I tried printing this three times with two different types of filament and two different build plates and all of them failed. It seems that it starts printing one of the objects in the air. I thought maybe it was the new film that I got , but after changing filament and build plates and just continued to do it. I even put it in silent mode Just slow it down and it still failed. I’m going to probably separate them to separate objects and print separately.
(Edited)1
Reply
Replying to @JBizzle
Agreed, this is an issue with the STL. The top half is a few layers off the bed, which is why some people might have issues with bed adhesion.
(Edited)1
Reply
Both objects are grouped on the file, and one of them is flying over the build plate. Straight spaghetti if you send straight to print.
0
Reply
Is it for D1 mini? Thank you.
0
Reply
Smaller modell
0
Reply
Print Profile
V2 0.16mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill
Support Issue:turned to spaghetti during printing of the supports
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld