Funnel Print-in-Place
Copyright Claim
Funnel Print-in-Place
Boost
29
53
10
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
![[A1 Compat]: 0.2mm layer, 2 walls, 15% infill](https://makerworld.bblmw.com/makerworld/model/USd7c295263507a6/design/2023-12-04_4b0fa4e9cb622.jpg?x-oss-process=image/resize,w_100/format,webp)
[A1 Compat]: 0.2mm layer, 2 walls, 15% infill
1.2 h
1 plate
Open in Bambu Studio
Boost
29
53
10
0
103
59
Released
Description
The diameter of the upper hole is 67mm/2,63inch and the diameter of the lower hole is 10mm/0,39inch.
Thank you for all the support.
Comment & Rating (10)
All
Print Profile
[A1 Compat]: 0.2mm layer, 2 walls, 15% infill
The print was okay, but at the end it was broken a bit.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
riktigt fin, skalade ner den till ett mindre format...
The designer has replied
1
Reply
Tack så mycket för din recension. Har du skalat ner det än? Blir den inte för liten?
(Edited)0
Reply
Nä den blev perfekt till mitt ändamål
(Edited)
0
Reply
a funnel is one piece how can it be print in place when that tends to imply multipole pieces
The designer has replied
0
Reply
because it is not a problem to print the funnel without supports and any modifications
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for 5* ^^
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for 5* ^^
(Edited)0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld