Terminator Pencil Holder
Remixed by
Terminator Pencil Holder
Remixed by
Boost
42
66
18
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7.8 h
1 plate
Boost
42
66
18
4
182
79
Released
Description
Remixed version of the Terminator skull
Comment & Rating (18)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed flawlessness in Sunlu Gray PETG. 0.12 layer height.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Had small issue with one of the hydraulic tube parts possible issue with my reel. Other than that looks really good. Very impressed. Thank you.
0
Reply
mine messed up with one of the hydraulic pipes but other than that was spot on
(Edited)
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Incredible design.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
très belle impression et rendu. une couche de peinture et une pointe de rouge et il est magnifique.
0
Reply
how to remove support columns on the jaw? Or is there a model without them?
0
Reply
mine had them on. I used a sharp knife and cut top and bottom. The larger supports I could snap with using force.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice without supports
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed really well. Its just a little bit too big for pens. Easily can be downsized a little.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
parfait
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
sehr schön und einfach zu drucken mit nur sehr sehr wenig Support.
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld