Controller and Headset Tower

I designed this for a friend of mine that needed a place to store their controllers, it requires a 608 bearing to rotate but it will probably still work without one because i designed the base and the stand with quite a tight fit for stability reasons so it doesn't rotate freely but after some time it spins a bit easier. you can place up to 4 controllers on this adjustable stand so far I've tested the xbox 360 controller, the xbox one/series X controller also the elite, a Playstation 3/4/and a knock off 5 controller a Switch Pro controller a wireless afterglow controller and just the joycon grip. And everything holds up well but some controllers require one of the different choosable angles. but you can also place two controllers on one side and an headset on the other.

It doesn't require the Bambu 608 bearing I just used some cheap ones I had laying around from Ali express. but I had to select the piece of hardware that was needed. but it will probalby also work without a bearing. Because It's a tight fit and when installing the bearing you would probably need to push it into the base with a piece of wood or something.

A comment, like or an photo of your make would be nice. And if anything should be changed or if something went wrong let me hear that as well so that I can have a look and get it solved.