Clean Bowden Y-Splitter
Remixed by
Copyright Claim
Clean Bowden Y-Splitter
Remixed by
Boost
67
156
59
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
44 min
1 plate
Open in Bambu Studio
Boost
67
156
59
3
687
380
Released
Description
Make of https://www.printables.com/model/584189-clean-bowden-y-splitter/files
A Y Splitter that looks native to the printer, use
https://au.store.bambulab.com/collections/pla/products/pla-sparkle or
https://au.store.bambulab.com/products/pla-basic-filament?variant=43466347348131
For good looks.
Comment & Rating (59)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Print is excellent.
There are two problems with this object:
1. The filament is often getting stuck inside the object.
2. The object can not be mounted with the existing screws of the printer (too short or to long).
(Edited)
The designer has replied
0
Reply
Yeah. You can use the long one with a washer maybe? Things may have changed in the recent builds. I'll take a look
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
打印成功
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I had to boolean cut the end back a little because my M6 connector wasn't as deep. Other than that, works fine.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Excellent design!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect print in Prusament PETG.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice design.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
sorry but thisnprinted with default settings way under sized.
The designer has replied
0
Reply
Thanks for the feedback, is it the outer box? I noticed that the outer box needs a bit of tighter snap in. I'll adjust it in the next version!
0
Reply
nope the entire thing was small wh n imported directly into bambu studio
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Tolerances way off when printed in PETG
(Edited)The designer has replied
0
Reply
hello! what issue did you run into running this print profile? appreciate your feedback and see if i can improve it in any way.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Filament gets stuck
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works perfectly
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld