Gridfinity USB-A Holder
Copyright Claim
Gridfinity USB-A Holder
Boost
112
322
78
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
28 min
1 plate
A1Mini Profile 0.2mm layer, 2 walls, 15% infill
33 min
1 plate
Boost
112
322
78
5
610
561
Released
Description
USB A holder for a 1X1 Gridfinity. Holds up to 8 USB drives. Spacing is wide enough to hold most flash drives or adapters. Designed this to replace my old non-gridfinity holder that I have used for many years.
Slight taper in the pockets, to help lock in the USB devices when inserted. Slightly oversized for a snug fit, without being too tight.
Print with the gridfinity base down. I normally use supports for the magnet holes. Any layer height should work, I use 0.2mm.
Need USB C instead? Check this out: https://makerworld.com/en/models/75455#profileId-79961
Need USB A & USB C? Check this out: https://makerworld.com/en/models/75457#profileId-79963
Comment & Rating (78)
All
Print Profile
A1Mini Profile 0.2mm layer, 2 walls, 15% infill
thanks for the A1 Mini Profile
The designer has replied
1
Reply
Hope you enjoy it :)
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works great for it’s intended purpose
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
10/10
0
Reply
Print Profile
A1Mini Profile 0.2mm layer, 2 walls, 15% infill
nice compact usb pen holder, nice fit..
0
Reply
Print Profile
A1Mini Profile 0.2mm layer, 2 walls, 15% infill
Great! Magnets on the bottom side help keep this small piece in place (and have no effect on USB drives).
0
Reply
Boosted
Print Profile
A1Mini Profile 0.2mm layer, 2 walls, 15% infill
bambu pla matt ash grey
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
really nice
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed well with wood PLA, thanks for the model
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
turned out fine!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very good
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld