Search models, users, collections, and posts
9V Battery Holder
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
23 min
1 plate
Open in Bambu Studio
Boost
64
150
19
8
285
170
Released
Description
This innovative holder lets you connect a 9V battery directly to flexible wires—no clips, adapters, or soldering required! Just wrap the exposed wire around the terminal contact points, pop in the battery, and you’re good to go!
Check out my other designs for AAA, AA, and 18650 batteries!
If you don't download the print profile, be sure to set the wall generator to Arachne, or it wont slice properly.
Leave a comment if there are changes you would like.
AA: https://makerworld.com/en/models/452852#profileId-360121
AAA: https://makerworld.com/en/models/457602#profileId-365598
18650: https://makerworld.com/en/models/464723#profileId-373406
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (19)