Y-Splitter_3D_Move_MagHolder
Remixed by
Copyright Claim
Y-Splitter_3D_Move_MagHolder
Remixed by
Boost
14
37
20
Print Profile(2)
0.12mm layer, 4 walls, 30% infill
Designer
57 min
1 plate
0.12mm layer, 4 walls, 30% infill, (Splitter with cuttable Support)
Designer
59 min
1 plate
Open in Bambu Studio
Boost
14
37
20
0
205
156
Released
Description
Y-Splitter move/turns in two Directions
Printed in ASA at low /quiet Speed
- use 3 x PC4-M10
- 1x Screw M3x12
- use 1 Pice of Rubber-Foam (dia 10mm x 2mm)
- second profile with extra cuttable support on the splitter for better bed adhesion
Comment & Rating (20)
All
Print Profile
0.12mm layer, 4 walls, 30% infill
Nice model. Easy print. Printed just with brim. No issue.
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
Filament slides very smoothly. Cheers.
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill, (Splitter with cuttable Support)
Leider nicht zu benutzen.. filament läßt sich mit diesen Druckereinstellungen kaum durch schieben..
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
does the job, but not very convenient to install
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
10/10 worked excellent
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
so smooooooth
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill, (Splitter with cuttable Support)
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld