[Print in Place] Foldable Spool Holder
Copyright Claim
[Print in Place] Foldable Spool Holder
Boost
25
45
8
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
25
45
8
0
57
26
Released
Description
Foldable filament spool holder so that it can be folded away when not needed.
Is held in position with a printed screw.
Comment & Rating (8)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Little problems with making parts move, sharp little knife needed but finally works as it should. Creator could make mirrored version too to put spool on from right side and to have screw in the front
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
ottimo file, proprio quello che cercavo per il mio progetto.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed well in petg. I printed 2 but broke the arm of one when trying to get the pivot to break free. The bottom layer its very tight around the pivot point but with a knife i was able to clean it up a bit
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld